Studi Desain Disposal Dan Perhitungan Kapasitas Out Pit Dump 3 Kabupaten Barito Selatan Provinsi Kalimantan Tengah
Disposal Design Study and Capacity Calculation of Out Pit Dump 3 in South Barito Regency, Central Kalimantan Province
DOI:
https://doi.org/10.58227/jesta.v3i2.298Keywords:
Disposal, volume, materialAbstract
Disposal is an area designed and planned to accommodate overburden material from mining activities. The objective of this study is to create a disposal design and determine its design volume capacity. The research methodology applies a technical approach, such as processing topographic data as the basis for design, utilizing the situational map of the disposal area as a reference, and considering production targets. Based on the conducted study, a disposal design was developed from the lowest to the highest elevation, starting from the requested elevation of 80 up to the peak design at elevation 120. The calculation of the design volume capacity resulted in a total of 11,410,645 Bcm, obtained from each design stage by elevation.
References
Abdelaal, S. M. E. (2014). Breaching of coastal barriers under extreme storm surges and implications for groundwater contamination: State of the Art Report. October, 90.
Abd, M. (2023). Rancangan Teknis Dan Penjadwalan Penambangan (Mine Schedulling) Pada Kuartal Iv Tahun 2022 Pt. Bumi Bara Makmur Mandiri Pit Tiga Kecamatan Batin Xxiv Kabupaten Batanghari Provinsi Jambi (Doctoral dissertation, Universitas Jambi).
Amalia, R., Fajrin, D., Anas, A. V., & Alimuddin, H. (2019). Perencanaan Disposal Semi Induced Flow dan Finger Flow di PT Vale Indonesia Tbk, Kabupaten Luwu Timur, Provinsi Sulawesi Selatan. Jurnal Penelitian Enjiniring, 23(2), 170–176.
Enim, M., & Selatan, S. (2020). Analisis Fondasi Disposal Tambang Terbuka PT Bara Anugrah Sejahtera , Analisis Fondasi Disposal Tambang Terbuka PT Bara Anugrah Sejahtera ,. July.
Gupta, T., Yellishetty, M., & Singh, T. (2019). Proceedings of the 27th International Symposium on Mine Planning and Equipment Selection - MPES 2018. Proceedings of the 27th International Symposium on Mine Planning and Equipment Selection - MPES 2018, September.
Harsiga, E., Pebrianto, R., & Prabowo, F. D. (2022, December). Rancangan Desain Disposal In Pit Dengan Metode Backfilling dan Menghitung Volume Material Timbunan Menggunakan Software Minescape 5.7. In Proceedings Of National Colloquium Research And Community Service (Vol. 6, pp. 149-151).
Kusuma, R. C. (2014). Evaluasi Desain Tahap 1 Disposal Swd 11 Pit 116 Tambang Batubara Distrik Baya Desa Separi, Kecamatan Tenggarong Seberang, Kabupaten Kutai Kartanegara, Kalimantan Timur. Geological Engineering E-Journal, 6(2), 602-617.
Marbun, T., & Puspita, M. (2024). Rancangan Penambangan Dengan Penanganan Material Opd Abc Timur Di Pit Middle Pt Banjarsari Pribumi. Jurnal Pertambangan, 8(1), 11-20.
Marit, F. A. Y., Nurhakim, N., & Saismana, U. (2022). Perencanaan dan desain disposal untuk Pit Central dan Pit North Tutupan di PT Adaro Indonesia. Jurnal Himasapta, 7(1), 51-54.
Prapassel, W. (2021). Rancangan Disposal Dan Drainase Di Pt Kamalindo Sompurna Kabupaten Sarolangun Provinsi Jambi (Doctoral Dissertation, Universitas Jambi).
Saputra, A., Azizi, M. A., Nugroho, B., Putra, D., & Marwanza, I. (2022). Perencanaan Penimbunan Disposal Penambangan Batubara Pit Ulakpandan Utara di PT Bumi Merapi Energi, Lahat, Sumatera Selatan. Indonesian Mining and Energy Journal, 5(2), 60-64.
Pengupasan, P., Tanah, L., & Overburden, P. (2020). Vol 06, no. 03, bulan juni, tahun 2020. 06(03).
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Journal of Engineering Science and Technology Applications
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
